Sonics GXE - Manual (Page 10)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L G X E P O W E R S U P P LY
9
I N S T A L L A T I O N
ELECTRICAL POWER REQUIREMENTS
The power supply requires a fused, single-phase, standard 3-terminal
grounding type receptacle capable of supplying the requisite voltage and
current. Refer to the table below for power specification.
SETTING UP
The power supply is a free-standing assembly. It should be installed in a
clear, uncluttered location that is free from excessive dirt, dust, corrosive
fumes, and temperature and humidity extremes. The selected installation site
should be near the electrical power source and away from equipment that
generates abnormally high electrical transients. Observe the following
additional instructions when installing the equipment:
a. Allow at least 6 inches (152.4mm) at the rear of the power supply for cable
connections.
b. Position the power supply so that the front panel controls are visible and
readily accessible.
c. The power supply is air cooled; allow sufficient space around the
assembly to ensure adequate ventilation. If the power supply must be
housed in a confined space, forced air cooling may be necessary to keep
surrounding air within acceptable ambient temperature limits. Periodically
check the ventilation grille and clean as necessary.
The line cord of the
controller/power supply
is equipped with a 3-
prong, grounding plug.
Do not, under any
circumstances, remove
the ground prong. The
plug must be plugged
into a mating 3-prong,
grounding type outlet.
POWER SPECIFICATIONS
NOTE: If power supply
is to be run
continuously, air cooling
of the converter and
horn is required. Use
clean, dry compressed
air filtered down to 5
microns (supplied to
converter fitting – see
page 13).
Power Rating/
Model Frequency 115 vac 230 vac
GXE400-40 400w - 40 kHz 15 amps 10 amps
GXE800-40 800w - 40 kHz 15 amps 10 amps
GXE1200-20 1200w - 20 kHz 15 amps 10 amps
GXE1700-20 1700w - 20 kHz N/A 20 amps
GXE2200-20 2200w - 20 kHz N/A 20 amps
GXE3500-20 3500w - 20 kHz N/A 30 amps
GXE2200-15 2200w - 15 kHz N/A 20 amps
GXE3500-15 3500w - 15 kHz N/A 30 amps
GXE4500-15 4500w - 15 kHz N/A 30 amps
Fuse Ratings
Go To Top Of Document