Cabletron Systems MicroMMAC 24T MICROMMAC- - Manual (Page 36)

3-1
CHAPTER 3
INSTALLATION
This chapter outlines MicroMMAC-T installation and network connection
procedures. Be sure that the network meets the guidelines and
requirements outlined in Chapter 2, Requirements/Specifications, before
installing the MicroMMAC-T.
3.1 UNPACKING THE MicroMMAC-T
Unpack the module carefully. Preserve and save all packaging materials
for possible storage or transport of the MicroMMAC-T.
Thoroughly inspect the MicroMMAC-T immediately. If there are any
signs of damage to the module, contact Cabletron Systems Technical
Support immediately.
3.2 ATTACHING THE STRAIN RELIEF BRACKET
Attach the strain relief bracket to the front of the MicroMMAC-T as
described:
1. From the MicroMMAC-T installation kit, locate the strain relief
bracket (shown in Figure 3-1) and four 8-32 x 3/8” screws.
CAUTION: Use of longer screws may cause damage to the unit or
electrical shock.
2. Attach the strain relief bracket to the bottom of the MicroMMAC-T as
shown in Figure 3-1.