TC-Helicon VoiceLive Touch User Manual - Manual (Page 18)

MERGE (default) - Keyboard controller data (MIDI notes and CCs)
are received via the MIDI In jack. USB sysex data (presets, updates) are
received via the USB jack. This allows you to load presets from
VoiceSupport and then immediately test them with a keyboard
controller if you like.
MIDI - Keyboard controller data and sysex are received via the MIDI
In jack only.The USB jack is ignored. Note that VoiceSupport updates
will not work because USB is required for this. Updates are possible
via the MIDI In jack but a sysex application is required as well as a
sysex header. Contact TC-Helicon support if you need to update your
product without USB.
USB - Keyboard controller data and sysex are received via the USB
input only. This is useful when you are using a DAW/MIDI sequencer
application to send keyboard notes to VoiceLive Touch and you want
the preset loading and version update features of VoiceSupport.
T
HE
A
DVANCED
S
ETUP
M
ENU
The Advanced menu contains less often used system-level parameters.
See previous to see how to access this menu.
1. Scroll Speed - Text scrolling speed in VoiceLive Touch can be increased
or decreased from the default value of 25. Numbers between 24 and 10
are faster and numbers between 26 and 50 are slower.
2. Lead Mute - Turns your dry lead voice off in all presets when set to
ON. This is useful when Touch is being fed via an auxilliary send on an
external mixer and there is already a dry lead path in the mixer. Note
that HardTune and Megaphone effects will be layered onto the dry
external voice where normally dry lead is muted in the preset.
Lead Delay - Can be used to compensate for the slight processing
latency of the harmony and doubling voices by delaying the dry lead
voice. When set to NONE (default), the lead voice is sent through
VoiceLive Touch with the shortest possible latency inherent to the
system. When set to VOICE SYNC, the lead voice is delayed.
Guitar Mute - Mutes the guitar signal in the main outputs when no jack
is connected to the GUITAR THRU jack.This allows the guitar dry signal
to be mixed externally. The guitar signal still feeds the NATURALPLAY
harmonies and tuner.
Undo - Setting this to OFF doubles looping time available at the expense
of the ability to undo the previous loop overdub.
Loop Feedback - Used to make each loop playback during overdubbing
fade in level if desired.The default is 98%.This will allow you to make a
loop that fades out gradually instead of stopping abruptly if you enter the
menu and set a lower value when you want to start fading out.
Output - This can decrease the overall output level of VoiceLive Touch in
the situation where the mixer you are connecting to is not capable of
accepting Touch’s full output without distorting.
TuneRef - This sets the overall tuning reference of the harmony voices
and HardTune with respect to A-440.This may become necessary when
performing with an instrument such as a piano where it’s overall tuning
has dropped. Note that dropped tuning on a guitar used to control
harmony does not require this parameter to be adjusted unless the
guitar is less than 100 cents detuned which is rare.
Advanced Setup Menu
19