TechniSat TechniVision ISIO 55 - Manual (Page 7)

7
4 Basic operation
Dear Customer
The following section starts by covering basic operation as well as recurrent operating steps
for the TV. This should make it easier to read the instruction manual, since it avoids repeated
description of identical steps at each individual stage.
If it is necessary for a function or setting for the TV to be different from the basic operation,
the difference in operation is described in detail in the relevant section in the instruction
manual.
The so-called "On Screen Display" is used on your TV. This simplifies operation of the
television since the buttons on the remote control can assume different functions. This makes
it possible to reduce the number of buttons.
In this
On Screen Display (OSD for short) the selected functions or settings are highlighted.
Furthermore, you will find a line along the lower edge of the screen in which the various
buttons on the remote control are shown with their current functions.
In this instruction manual the terms shown in the OSD as well as
the buttons to be pressed are highlighted from the rest of the text by the display format
used.
Warning - indicates an important note which you absolutely should observe in order to
avoid problems with the television, loss of data or unwanted operation.
Tip - indicates a note about the function being described, as well as other associated
functions that may need to be observed with reference to the respective place in the
instruction manual.
4.1 Switching the television on/off
> When the television is on standby, you can switch it on by pressing the
On/Standby button on the remote control/device.
> When operating normally you can switch the device to standby mode by pressing the
On/Standby button.
When switching the TV on/off, also observe section 7.1 in the instruction manual as
well as the instructions given under this point.