TeeJet LH 3000 - Manual (Page 11)

LH 3000 OPERATING MANUAL
LH AGRO 11
04 BOOM SECTION
Is electronic for boom compensation fitted the LH 3000 can take account for
shutting of one or several sections when calibrating area and chemical
consumption. To enable the monitor these calculations the following must be
encoded:
A. Number of sections of the boom.
B. The width of the individual sections.
Use the following procedure:
Choose ENCODE 04. The display changes between 04 to the left and another
figure to the right.
A:
1.
Encode the number of sections on the numerical keyboard.
2. Press MEMO and 2 horisontal bars are displayed.
B:
LH 3000 is now ready for encoding of the individual section widths. This
programming has connection with the sprayer’s operation panel. The switches for
the individual sections will be lit one by one from the left to the right and the width
is encoded as follows:
1.
Set the switch for the left section on. “01” will now flash to the left in the
display. Encode the width of the section in cm, and set the switch off again.
2. Set the switch for the second section from the left on. “02” will now flash.
Encode the width of this section in cm, an set the switch off again.
3. All sections are to be encoded as described under 1 and 2.
4. As a control all switched will be lit at one time. The sum of all the encoded
sections will now be equal to the working width of the sprayer (encoding
value 01).
Exit encoding of SECTIONS by the “SYSTEM”-key.
NB!
The encoding of sections must be completed when started. The encode cannot be
exited until widths of all sections encoded before has been made.
Does the number of encoded sections not correspond with the number of lit
section switches “ERR 8” will be displayed.
Does the encoded working width not correspond with the monitor will display “ERR
9” and the faulty encoding must be corrected.