Test of sensors, Speed sensor flow meter prm sensor – TeeJet LH 3000 User Manual
Page 22
LH 3000
OPERATING MANUAL
22
LH A
GRO
TEST OF SENSORS
Encode a working width of 6666 as follows:
Press
for app. 3 seconds until the display changes between 01 and the
encoded working width and the numerical keyboard is lit.
Encode 6666.
Press
and the display shows "TEST" (flashes).
The individual sensors can now be tested.
SPEED SENSOR
Press
To the left in the display the sensor selected in "ENCODE" will be shown.
h1 = speed sensor on tractor
h2 = speed sensor on implement
h3 = radar
To the right the display will show:
"ON" = sensor active
"OFF" = sensor not active
Flashes if there are pulses.
FLOW METER
Press
"F" appears to the left in the display. To the right "ON/OFF" will flash when the
paddle wheel in the flow meter is turned.
PRM SENSOR
Press
"P" appears to the left in the display. To the right "ON/OFF" will be flashing when
the PRM sensor is activated.