TeeJet LH 3000 - Manual (Page 9)

LH 3000 OPERATING MANUAL
LH AGRO 9
01 WORKING WIDTH
The working width is the width measures in cm represented by the implement.
Thus 1500 has to be encoded for a 15 m sprayer.
NB!
If boom compensation has been fitted the individual section must be
encoded under “04 section”.
Exit the encoding as described above when completed and the new value will be
stored automatically in the memory.
Encode as follows:
Press for about 3 seconds.
The display will now show 01, indication “encoding 01”, and a figure (say 1200)
indicating the encoded working width.
Nov this value can be changed by means of the numerical keys (visible when
encoding).
Example:
The working width must be changed from 1200 cm to 1500 cm.
1.
Press “SYSTEM” for 3 seconds and “01” and “1200” will be displayed by
turns.
2. Now enter 1500 by the numerical keyboard. This value will flash to the right
in the display.
3. Press “SYSTEM” for 3 seconds until the lit figures come off.
The monitor has now deleted 1200 and stored a new working width of 1500 cm.
The other encoding values will be described one by one on the following pages.
02 WHEEL CIRCUMFERENCE
The wheel circumference is the distance travelled by the vehicle by one revolution
of the wheel.
Encoding values are determined as follows:
Method 1:
Use this method when speed sensor has been fitted at wheel.
1.
Mark out in the field and at the wheel.
2. Make 10 turns with the wheel.
3. Again mark out in the field.
4. Measure the distance between the two marks and divide by 10.
5. Divide the wheel circumference by the number of magnets.
NB!
The turns must be counted of the wheel on which the magnet is
fitted.
6. The result is the effective wheel circumference. Encode in cm. E. g. 2,53 m
to encode as 253 cm.