TeeJet LH 3000 - Manual (Page 19)

LH 3000 OPERATING MANUAL
LH AGRO 19
APPLICATION
By pressing this key the actual application in litres per hectare is displayed.
WARNING: To control the application rate the wanted rate is encoded here as
follows:
1. Press for app. 3 seconds until the figure keys are lit.
2. Encode the wanted application.
3. Press again.
NOTE: The maximum deviation is encoded during the encode (“SYSTEM”-key)
point 07.
The warning function is only active when the implement works.
AUTOMATIC APPLICATION: The wanted application rate for automatic
applications is encoded as above under warning. The monitor will then control the
application rate comparred to forward speed.
NOTE: The prescribed working pressure for the used nozzles must be kept.
Warning for pressure or over/under application is a good control that the
automatic application is operating as it should.
By encoding an application rate of “0” the motor valve can be regulated up or
down manually by pressing the “+” and “-“ keys respectively.
PLUS/MINUS APPLICATION CHANGES
The automatically controlled application is increased by a pre-encoded per cent
rate when pressing the “plus” key. The “minus” key reduces the automatic
application rate correspondingly.
This function presupposes programming. See Encode point 09.
EXAMPLE:
The application will be increased by 5% when activating the
“PLUS” key if a 5% deviation has been encoded.
Is the key pressed again the application rate will be increased by 10%, etc. The
application rate can be stepped maximum 5 times. By pressing the “MINUS” key
the application is reduced correspondingly.
If the “PLUS” or the “MINUS” key is activated the display will change between the
actual function choise and a figure indicating per cent of over or under application.
By pressing the key it is returned to original application rate.