Canon Z5000 - Manual (Page 155)

A
A-1 Token Ring Network Option
Token Ring is an alternative network architecture to Ethernet architecture. Token Ring
networks offer a high resistance to failure and are commonly used in large or
high-traffic network installations.
Token Ring networks operate by passing a network token around the electronic
equivalent of a ring. The token is a data packet that circulates from one network
node to another, controlling access to the network. In practice, each workstation is
connected to a port on one or more media attachment units (MAUs) which act as
network hubs for the ring connection.
This appendix describes the Token Ring option and cable connections, and refers you
to the remaining configuration required for printing to the ColorPASS.
ColorPASS Token Ring option
The ColorPASS supports Token Ring networks that use IPX and TCP/IP protocols. To
use the ColorPASS with a Token Ring network, a Token Ring network interface card
provided by EFI must be installed in the ColorPASS. You can use either shielded
twisted pair (STP) or unshielded twisted pair (UTP) cable.
Connecting Token Ring hardware
The service/support center that installs the ColorPASS typically also installs the Token
Ring option at the same time and configures the ColorPASS to enable printing.
Appendix A:
Token Ring
Network Option