Canon Z5000 - Manual (Page 52)

3
3-16 Performing Setup from the Control Panel
Select protocol
DHCP/BOOTP/RARP [DHCP]
This option appears only if you answered Yes to Enable Auto IP Configuration. Select
the protocol over which the ColorPASS should search for its IP address. Both DHCP
and BOOTP allow the ColorPASS to obtain the Ethernet IP address and Subnet Mask
automatically. RARP obtains only the Ethernet IP address.
Depending on your network, the ColorPASS might be assigned a different address
after you reboot the ColorPASS. With the DHCP setting, the ColorPASS can be
assigned a different address even if it is not rebooted. Make sure the network is already
configured properly for the protocol you select.
Get Gateway Address Automatically
Yes/No [Yes]
Use this option to get the gateway address automatically for printing with TCP/IP.
This option appears only if you selected DHCP or BOOTP as the protocol in the
previous option.
If you select a DHCP or BOOTP protocol and later change it to RARP, you must
return to Setup and set this option to No. You can then set the address manually. This
is because RARP does not support automatic assignment of the gateway address.
IP Address
[127.0.0.1]
Enter the ColorPASS IP address for Ethernet. This IP address, unlike an IP address set
automatically, remains the same if you reboot the ColorPASS. You must change the
default to a valid address for your network. For information about setting up printing
with TCP/IP, see Chapter 5.
Subnet Mask
[255.255.255.0]
This option lets you modify the subnet mask for printing with TCP/IP over Ethernet.
To set the subnet mask, enter one of the following values:
• 255.0.0.0 if the IP address starts with a number less than 128
• 255.255.0.0 if the IP address starts with a number from 128 through 191
• 255.255.255.0 if the IP address starts with a number greater than 191