Canon Z5000 - Manual (Page 24)

1
1-10 Connecting to the Network
Connecting network cable to the ColorPASS
In this section, the back panel of the ColorPASS is illustrated, followed by information
for connecting to the Ethernet board. For information about connecting to a Token
Ring network, see Appendix A, “Token Ring Network Option.”
Shut down the ColorPASS before attaching it to any network device. If the ColorPASS
has just finished processing, wait 5 seconds after the system reaches the Idle state before
using the power switch to turn off the ColorPASS.
Back view of the ColorPASS
!
10/100BaseT Ethernet (RJ-45)
Copier interface connector