TeeJet FieldPilot Install Miller 22xx T T-SS T-ET HT - Manual (Page 15)

13
FieldPilot ®
98-05232 R0
6. install Pressure hose
Locate an existing run tee in the excess flow line exiting the priority valve. Disconnect the existing pressure hose
attached to branch of run tee. Install run tee (N) to branch of existing run tee on Nitro. Reconnect original hose to
the run of the tee. Then connect hose (L) from the branch of the new TeeJet run tee to the pressure port of the
FieldPilot valve. Hose will route down from FieldPilot valve along the cross over beam.
Figure 1-9: Install Pressure Hose
l
n
l