Clarion DXZ955MC - Manual (Page 35)

280-8036-00
English
DXZ955MC
35
Sound Adjustment
Notes:
• The screen displayed in step 3 appears, with the
title being accompanied by “ ✓” mark.
Operation so far completes P.EQ adjustment. To
continue to store the adjustment value to the
P.EQ user menu, perform the following.
12. Touch [PRESET] to display the P.EQ menu
list.
13. Touch and hold [USER] for 2 seconds or
longer.
You will hear a long beep, and the values
you adjusted up to step 10 are stored to the
P.EQ menu.
If you hear a short beep, the adjustment
values up to step 10 are discarded. Adjust
these values again as required.
14. Press the [SOUND] button to return to the
original mode.
Dolby Pro Logic II
Dolby Pro Logic II is a matrix decoding
technology in which updated digital matrix
technology is applied and Dolby Pro Logic is
further improved. Dolby Pro Logic II realizes
excellent 5.1 channel reproduction of Dolby
surround source as well as stereo sound
sources such as CDs, thereby causing a
surround channel to be full-ranged (20 Hz to 20
kHz) and become stereo. Therefore, you can
enjoy any stereo sources with dynamic sound of
5.1 channel. The Music Mode or Matrix Mode
can be selected according to a source to be
reproduced.
This product is manufactured under license from
Dolby Laboratories. “Dolby”, “Pro Logic” and
the double-D symbol are trademarks of Dolby
Laboratories.
Selecting the PL II menu
(Dolby PL II)
This is available only when the speaker system
is set to “Dolby PL II”.
Select the MUSIC mode or the MATRIX mode
matched the source you are to play as the Dolby
Pro Logic II mode.
• The factory default setting is “MUSIC”.
■ MUSIC (music mode)
• This mode is suited for stereo sound sources
such as CDs.
• Another adjustment mode (PL II CONT) that
enables more detailed adjustment is also
available because the sound field spreads
differently depending on the state of the
recorded music source. (See page 36)
■ MATRIX (matrix mode)
• This mode is suited for sound sources such as
AM/FM radio.
1. Press the [SOUND] button.
2. Touch [Dolby PL II].
FILTER FADER
RTN
OFF MUSIC 0 0
SOUND
ADF
SP
GAIN BALANCE
1 2
Dolby
PL
The mode display is switched as follows:
MUSIC (music mode) ➜ MATRIX (matrix
mode) ➜ MUSIC (music mode)...
3. Press the [SOUND] button to return to the
original mode.
* For details on the volume adjustment of
the center speaker/sub-woofer, see page
31.
Adjusting the speaker gain
level
Use the built-in test tone function so that the
gain levels from all speakers become equal.
• The SP GAIN menu can be adjusted only
when the Pro Logic II mode is set to “MUSIC”
or “MATRIX”.
• The factory default setting is “0dB”.
1. Press the [SOUND] button.
2. Touch [SP GAIN].
SP GAIN MODE
RTN
FRONT - L 0dB
3. Touch on the left of the display to
select an item.
Each touch switches the adjustment item as
follows:
+DXZ955MC_01-27-Eng.p65 05.1.17, 5:16 PM 35