Canon DR-5020 - Manual (Page 35)

34
Chapter 2 Preparation Before Use
In the case of “Update Device Driver Wizard” (Windows 95), click Next and then click
Finish on the next screen.
In the case of “Add New Hardware Wizard” (Windows 98), follow the procedure
described below.
1. Click Next.
2. Select “Search for the best driver for your device (Recommended)” and then click
next.
3. Clear all checkmarks and then click Next.
4. Click Next.
5. Click Finish.
In the case of “Add New Hardware Wizard” (Windows Me), select “Automatic search
for a better driver (Recommended)”, then click Next and then click Finish on the next
screen.
In the case of “Found New Hardware Wizard” (Windows 2000), follow the procedure
described below.
1. Click Next to advance to the “Install Hardware Device Drivers” screen.
2. Select “Search for a suitable driver for my device (recommended)”, and then click
Next to proceed to the “Locate Driver Files” screen.
3. Clear all of the checkmarks in the “Optional search locations”, and then click Next
to proceed to the “Driver Files Search Results” screen.
4. Select “Disable the device.” and then click Finish.
In the case of “Found New Hardware Wizard” (Windows XP), follow the procedure
described below.
1. Select “Install the software automatically (Recommended)” and click “Next” to
start searching the software.
2. After the searching is completed, the message “The wizard could not find the
software on your computer for...” appears. Select “No, do not connect to the
Internet now” and click “Next”. (If your computer is connected to the Internet, this
message does not appear.)
3. When the message “Cannot Install this Hardware” appears, select “Don’t prompt
me again to install this software” and click “Finish”.
• After the “Found New Hardware Wizard (Windows XP)” terminates, the message “A
problem occurred during hardware installation. Your new hardware might not work
properly,” appears in the taskbar. This message does not indicate a problem with the
scanner. Simply click on the “X” to close the message window.
• The driver application provided with the scanner must be installed to use the scanner.
For details, refer to the separate “ISIS/TWAIN Driver Instructions” or “Scanning Utility
5000 Instructions.”
Turning the Power OFF
For your safety, disconnect the power plug from the power outlet if you are not using the
scanner for a long time.
1
Turn the computer OFF.
2
To turn the scanner OFF, press the power switch.
Wait at least 10 seconds before turning the scanner ON again.
CAUTION
CAUTION