Toa SV-200MA - Manual (Page 48)

48
24.5. Recorded Message-to-Group Assignment Operation
Here, the operation example of assigning Recorded Message 1 to Broadcast Groups 1, 3, and 4 will be
explained. (See p. 42 "Message 1 to group" setting example.)
Step 1. Entry to recorded message setting mode
Press and release the Reset key while holding down the
ZONE 1 and ZONE 3 keys. When all indicators for
Zones 1 – 5 begins to flash (2 – 3 seconds after),
release both the ZONE 1 and ZONE 3 keys.
The unit will be placed in recorded message setting
mode.
The 5 indicators for ZONE 1 through ZONE 5 begin to
flash. (They indicate Message 1 through Message 5.)
Operations of Steps 2 – 6 described hereafter are the same as those described in the previous section Control
input/Telephone paging/Westminster chime-to-Group assignment. However, read 5 setting items of Inputs 1 –
3, TEL paging, and Westminster chime as Messages 1 – 5.
Shown on the right is the status of each indicator that results
from the group number setting (Example. Groups 1, 3, and 4)
performed in Step 4.
ZONE 1 ZONE 3 Reset
ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 ALL
Message 1 Message 5
ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 ALL
Group 1
(Message 1) Group 5