Toa TS-910 Series Installation - Manual (Page 32)

32
Infrared transmitter/receiver Distributor
Central unit
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
M
M M
M
N
When installing in the same space,
• All "L" cables must be identical in length
• All "M" cables must be identical in length.
Note
To facilitate the unification of coaxial cables used in
different connections into the same length, it is highly
recommended that wiring from the Central unit to the
distributor mounted in a ceiling be performed with
a single cable. For other ceiling wiring, using pre-cut
coaxial cables of a slightly longer length will facilitate
making all connections the same length.
(Example 2)
6.4.3. Wiring examples
(Example 1)
Infrared transmitter/receiver
Central unit
N
N N
N
All cables for "N" must be identical in length when the Infrared
Transmitter/Receiver unit and the Central unit are installed in the
same space.
Infrared transmitter/receiver
Distributor
Central unit
L1
L1
L1
L1
L0
L0
L0
L0
L0
L0
L0
L0
M1 M0
M0
N
Conference room A
Conference room B
(Example 3)
When installing in multiple rooms where the light is
shut off, coaxial cables used in different rooms need
not be matched to the same length.
• All L0 cables are the same length.
• All L1 cables are the same length.
• All M0 cables are the same length.
• L0 and L1 cables need not be the same, since they
are used in different rooms.
• M0 and M1 cables need not be the same length,
since they are used in different rooms.
Note
The above condition also applies to cases in which two
conference systems, both including the Conference
units, are apart from each other in the same room so
that communications cannot be made between the two
systems.