Toa TS-910 Series Installation - Manual (Page 37)

37
Attaching a YA-641 BNC Plug to the RG-6/U Cable
Step 1. Strip the jacket 10 mm from the end of the coaxial cable.
Step 2. Unravel the braided shield and turn it back, then peel away the
aluminum cladding.
Step 3. Strip the dielectric 4 mm from the cable end.
Step 4. Disassemble the BNC plug as shown in the figure at right and turn
the screw on the plug so that it loosens partially but remains in
position.
Step 5. Insert the coaxial cable into the clamping fixture.
Step 6. Insert the clamping fixture assembly into the plug.
Step 7. Tighten the screw and then clamp the plug by tightening the
clamping fixture.
Step 6. Insert the coaxial cable into the clamping fixture.
Step 7. Insert the clamping fixture assembly into the plug and then solder
the conductor.
Step 8. Insert the plug into the BNC connector.
Step 9. Clamp the connector by tightening the clamping fixture.
BNC connector Clamping
fixture
BNC connector
Clamping fixture
Solder.
Conductor
(Finished)
10 mm
4 mm
Aluminum cladding
Braided shield
Conductor
Dielectric
Plug
Plug
Clamping
fixture
Screw
Plug
Screw
Clamping
fixture
Clamping fixture
(Finished)
10 mm
4 mm
Aluminum cladding
Braided shield
Conductor
Dielectric
Attaching a CC-4900 BNC Plug to the RG-6/U Cable
Step 1. Strip the jacket 10 mm from the end of the coaxial cable.
Step 2. Unravel the braided shield and turn it back, then peel away the
aluminum cladding.
Step 3. Strip the dielectric 4 mm from the cable end.