Flash-to-pass, Windshield wipers, Flash-to-pass -10 windshield wipers -10 – Cadillac 2011 DTS User Manual

Page 172

Advertising
background image

Black plate (10,1)

Cadillac DTS Owner Manual - 2011

Other Messages

There are three messages that may appear on the
Driver Information Center (DIC). They are CLEAN
RADAR, RADAR CRUISE NOT READY and SERVICE
RADAR CRUISE. See DIC Warnings and Messages on
page 4‑65
.

Cleaning the System

The radar can become blocked by snow, ice, or dirt.
If so, you may need to turn off the engine and clean the
lens. See “Cleaning the System” under Adaptive Cruise
Control on page 4‑14
.

Flash-to-Pass

This feature lets you use the high-beam headlamps to
signal the driver in front of you that you want to pass.

The flash-to-pass feature will only work with the
headlamps on. It does not work with Daytime Running
Lamps (DRL).

Pull and hold the turn signal lever toward you to use.

If the headlamps are on low beam, pulling the turn
signal towards you will flash the high beams.

Windshield Wipers

The windshield wiper lever is located on the left side of
the steering column.

Turn the band with the wiper symbol on it to control the
windshield wipers.

8(Mist): For a single wiping cycle, hold it on mist until
the wipers start, then release. The wipers stop after
one wipe. Several wipes, hold the band longer.

6

(Delay): Use to set the delay time between wipe

cycles. The wiper speed can be set for a long or short
delay between wipes. The closer the band is set to the
top of the lever, the shorter the delay.

4-10

Advertising