Cadillac 2011 DTS - Manual (Page 343)

Black plate (33,1) Cadillac DTS Owner Manual - 2011
Adding Washer Fluid
The WASHER FLUID LOW ADD FLUID message will
be displayed on the Driver Information Center (DIC)
when the fluid is low. See DIC Warnings and Messages
on page 4‑65 for more information.
Open the cap with the
washer symbol on it.
Add washer fluid until the
tank is full. See Engine
Compartment Overview
on page 6‑14 for
reservoir location.
Notice:
. When using concentrated washer fluid,
follow the manufacturer's instructions for
adding water.
. Do not mix water with ready-to-use washer
fluid. Water can cause the solution to freeze
and damage the washer fluid tank and other
parts of the washer system. Also, water does
not clean as well as washer fluid.
. Fill the washer fluid tank only three-quarters
full when it is very cold. This allows for fluid
expansion if freezing occurs, which could
damage the tank if it is completely full.
. Do not use engine coolant (antifreeze) in the
windshield washer. It can damage the
windshield washer system and paint.
Brakes
Brake Fluid
The brake master cylinder
reservoir is filled with
DOT 3 brake fluid. See
Engine Compartment
Overview on page 6‑14
for reservoir location and
access.
There are only two reasons why the brake fluid level in
the reservoir might go down:
. The brake fluid level goes down because of normal
brake lining wear. When new linings are installed,
the fluid level goes back up.
. A fluid leak in the brake hydraulic system can also
cause a low fluid level. Have the brake hydraulic
system fixed, since a leak means that sooner or
later the brakes will not work well.
6-33