Toa C-CC574 PL - Manual (Page 25)

25
13. Attach the safety wire attached to the base unit to the saddle bracket of the suspension pipe.
14. Attach the base unit (with footing) to the suspension pipe.
Oval hole in the saddle bracket
M4 x 20 Camera mounting
screw
M5 x 20 Safety screw
Base unit
Camera
directio
n
Screw head
sliding direction
• Run the camera mounting screw head (2 screws) through the oval hole in the saddle bracket, and slide it in
the direction indicated by the arrow, then tighten the camera mounting screws.
• Tighten the safety screw and run its screw tip through the round hole in the saddle bracket.
Note: Ensure that camera mounting screws and safety screw are securely tightened.