3 indicator functions – Triner Scale RAVAS-310 User Manual
Page 12
12
3.3 INDICATOR FUNCTIONS
GRADUATION
From 0 to 5000 lbs the weight is shown in 2 lb increments.
BEFORE WEIGHING: CHECK ZERO POINT
Before each weighing it is necessary to check whether the system is unloaded and
free. The indicator is fitted with an automatic zero correction. This means that small
deviations of the zero point will be corrected automatically. If the indicator does not
determine the zero point automatically, it must be done manually by pressing the >0<
key.
GROSS WEIGHING
After lifting a load, the display shows the gross value of the weighed load.
NET WEIGHING: AUTOMATIC TARE
The indicator offers the possibility to reset tare weights to zero automatically. This
way added or subtracted weights can be determined.
Lift load.
Press key T.
The indicator is set to zero.
The "NET" pointer shows that a tare weight is activated.
Place or remove the net load.
The display shows the net value of the weighed load.
When load is removed, a negative weight is displayed.
By pressing the T key again, the gross weight is displayed.
NET WEIGHING: MANUAL TARE ENTRY
A tare weight can be entered at any time, either in a loaded or unloaded situation.
Press the
PT key until the display changes and the last digit is blinking (approx 3
seconds).
The display shows the current tare value.
The right digit is blinking.
Press ENTER (
) if the current tare value is correct.
Or