Twin Eagles TEBQ30R-B - Manual (Page 13)

ELECTRICAL REQUIREMENTS –
T WIN E AGLES G AS G RILL
TO INSTALL AND SECURE POWER TRANSFORMER
All grill models are supplied with a power transformer which is concealed in a stainless steel box
with an attached power supply cord and installed wire harness. It must be connected to the grill and
plugged into an electrical outlet in order to power the lights and ignition system. This transformer
must be secured in a dry location and away from the grill firebox and excessive heat area.
1a. In a base cart application, two mounting screws with nuts are provided at the bottom right rear
corner of the cart. If not provided, drill two holes using the transformer box as a template.
Secure the transformer box as shown.
1b. In an island application, secure the transformer box near the GFCI 120V outlet in a dry location
and away from the grill firebox and excessive heat area.
2a. Make the transformer connections to the wire harness located at the right rear of the grill to
the harness of the transformer box.
2b. Plug-in the transformer’s power cord to the properly grounded GFCI 120V outlet.
AVERTISSEMENT
Instruction pour la mise à la terre electrique:
Cet appareil est muni d’une fiche à trois broches
(mise à la terre) afin de vous protéger des chocs
et doit être branché directement dans une prise
de courant à trois broches adéquatement mise à
la terre. Il ne faut pas couper ou enlever la
broche de mise à la terre de cette fiche.
WARNING
Electrical Grounding Instructions:
This outdoor gas cooking appliance is
equipped with a three prong (grounding) plug
for your protection against shock hazard and
should be plugged directly into a properly
grounded three prong outlet. Do not cut or
remove the third prong from this plug.
1a.
ROTISSERIE MOTOR:
The rotisserie motor requires 120 volt supply. The power supply cord on the motor is equipped
with a 3-prong (grounded) plug for protection against shock hazard. Do not cut or remove the
grounding prong from the plug.
9
2a .
1b . 2b .