Twin Eagles TEBQ30R-B - Manual (Page 18)

ASSEMBLY INSTRUCTIONS –
T WIN E AGLES G AS G RILL
The T WIN E AGLES Grill is produced fully assembled and tested in the factory and requires no
major assembly in the field. For the purpose of safe shipping and transit, some parts such as the
briquette trays and rotisserie components are wrapped inside the grill and require minor assembly.
Check to ensure that all packaging material have been removed prior to grill operation.
TO INSTALL BRIQUETTE TRAYS:
1. Briquettes trays and grill hex grates already installed but
packaging material may be needed to be removed.
2. Put the briquette trays with the briquettes into the grill abhe
burner, as shown.
3. Place the hexagonal grates directly above the briquette trays
and make sure the square openings on the grates are a
Z
TO INSTALL BRIQUETTES TRAYS
1. Put briquette trays into the grill above the burner, as shown
by placing the flash-tube-hole on the front.
2. Place the hexagonal grates directly above the briquette
trays and make sure the square openings on the grates
are at the front.
TO INSTALL AND USE THE SMOKER BOX
1. Lift open smoker box lid and add smoking chips with water.
2. Remove a hex grate. Remove a ½ sized briquette tray
where there is no flash tube.
3. Place the smoker box in place of the briquette tray and the
smoker box will always line-up on top of the burner flame.
Place hex grate back over the smoker box. Turn on grill to
HIGH heat. Once smoking starts, turn the heat down to
prevent wood flare-up. Smoker box is standard on all
grills.
4. Warning: Do not use smoker box over the sear burner.
WARMING RACK LEVEL POSITIONS:
The warming rack may be used at a HI and LOW level position.
The HI level is further away from the heat source while the
lower level position is closer to the heat source.
When the warming rack is not in use, it may be moved out of
the way by moving up to the top support hooks.
14
HI POSITION
LOW POSITION STORED POSITION