TYREDOG TD-4100A-X - Manual (Page 14)

V1.01-FJ04 (1105068)
14
B. Insert lithium battery and make sure battery polarity correct
when insert it.
Right now, monitor will receive signals from corresponding
sensors and report pressure value on the screen. At first, you will
find that the value shows “00.0”. It is because sensors have not
been mounted yet. The screen could show as below.
Take number 1 for example
Note：After take away battery, the status of being without battery
need to leave for 10 seconds and then insert battery again.
It is for resetting system.
Blinking