VACUUBRAND MV 10C NT VARIO - Manual (Page 65)

page 65 of 145
The screen-shot shows the factory-set values.
Editing:
+
To select row: turn and press selection knob.
+
To adjust parameter: turn the selection knob.
+
To confirm parameter: Press selection knob. Controller will accept
change and jump to the next parameter in the same row.
+
After 5 seconds without a change, the parameter is assumed to be the
current setting. Select the next row to edit or return to the Program menu.
➨
In case, store an edited program after having quit ”Edit” by storing it to
one of the storage spaces 0 - 9 (select ”Store”).
1013 mbar
00:28:00
Program 5 : 4 1013mbar
Program
Edit
Open 0
Store 0
Delay Off
- - - - - - Graphic - - - - - -
- - - - - - - Back - - - - - - -
00:00:00
When selecting ”Graphic”, the display shows a pressure vs. time curve.
Program number, and the step number in that program, along with the
vacuum setting, the actual current pressure and the actual runtime are
displayed across the top.
The timeline in the diagram adapts automatically to the process time.
+
Press the selection knob twice to return to the standard display.
The most recent process (except in ”VACUULAN” function) is stored in
the temporary data memory as long as the controller stays switched on.
This program can be transferred to a storage space and edited.
Once the program is finished, the clock symbol starts to flash. Confirm the
end of the program by pressing START/STOP (clock symbol will disappear).
Attention: If ”Autostart” is set to ”On”, the program will start again
(time will be reset to 00:00:00) after a power failure or after switch-
ing the controller off/on. Only if the end of the program (clock symbol
flashing) has been confirmed by pressing START/STOP, the program will
not start again.