Wilson Audio Mezzo Convergent Synergy - Manual (Page 28)

found at certain discreet locations in the room. These locations differ according to room
dimension and size. A room generating severe standing waves creates difficulty in setup. In
these rooms, the speaker will sound radically different as it is moved around. The effects
of standing waves on a loudspeaker’s performance are primarily in the areas listed.
• Tonal balance
• Resolution of low-level detail
• Soundstaging
Standing waves are more difficult to correct than slap echo because they tend to oc-
cur at a lower frequency. Absorbent materials, such as Illbruck Sonex®, are ineffective at
controlling reflections in the bass region. Moving speakers about slightly in the room is, for
most people, their only control over standing waves. Sometimes a change of placement of
as little as two or three inches can dramatically alter the tonal balance of a small system.
Fortunately, minor low frequency standing waves are well controlled by positioning
ASC Tube Traps™ in the corners of the room. Very serious low frequency accentuation
usually requires a custom-designed bass trap system.
Low frequency standing waves can be particularly troublesome in rooms constructed
of concrete or brick. These materials trap the bass in the room unless it is allowed to leak
out of the room through windows and doors.
In general, placement of the speaker in a corner will excite the maximal number of
standing waves in a room and is to be avoided for most direct radiator, full-range loud-
speaker systems. Some benefit is achieved by placing the stereo pair of loudspeakers
slightly asymmetrically in the listening room. This is so the standing waves caused by the
distance between one speaker and its adjacent walls and floors are not the same as the
standing wave frequencies excited by the dimensions in the other channel.
M
e z z o
C
o n v e r g e n t
S
y n e r g y
o
w n e r
’
S
M
a n u a l
28
W i l s o n A u d i o S p e c i a l t i e s
.