Wilson Audio Mezzo Convergent Synergy - Manual (Page 39)

Note: Before setting up the Mezzo Convergent Synergy, study carefully Section 3, “In
Your Room.” It provides valuable information on determining the ideal room location
for your speakers.
Section 4.1—Initial Setup
Preparation
You will need the following items:
• Supplied hardware kit
• Tape measureKnown listening position
Your dealer is trained in the art and science of the Wilson Audio Setup Procedure
(WASP) outlined in Section 3, and Wilson Audio recommends dealer installation of your
new loudspeaker.
Section 4.2—Mezzo Convergent Synergy Spikes
Note: Please read Section 5—Final Voicing before spiking the Mezzo.
The Mezzo Convergent Synergy comes with hardware necessary to properly spike it
to the floor. This will allow the speaker to be tilted to a variety of angles. These spikes also
provide acoustical isolation as well as optimal height placement for your speakers. There
are three ways of assembling the spikes (without diodes, without spacers, or with one or
two spacers), and your choice will depend on the location of the Mezzo Convergent Syn-
ergy and personal tastes. While the Mezzo Convergent Synergy baffle is designed such that
the front baffle is angled upward toward the listener, the spacers are provided to allow for
additional rotation of the Mezzo Convergent Synergy, such as for installations where the
listening position is close to the loudspeakers. If the speaker is floor mounted, additional
upward tilt may be desirable so the drivers are firing towards the listener. If the speaker is
s
e C T i O n
4 . 1 — i
n i T i a l
s
e T u p
39
W i l s o n A u d i o S p e c i a l t i e s
.