Campbell Hausfeld Serial I/O Interface SDM-SIO4 - Manual (Page 65)

Section 6. Data Error Detection
6-9
*Table 1 Program
01: 1.0 Execution Interval (seconds)
;use formatter string 100 to set up the CRC16 on port 1
1: SDM-SIO4 (P113)
1: 1 Reps
2: 0 Address
3: 1 Send/Receive Port 1
4: 2304 Command
5: 9100 1st Parameters
6: 0 2nd Parameters
7: 0 Values per Rep
8: 0000 Loc [ _________ ]
9: 1 Mult
10: 0 Offset
;A minimum delay of 1ms is required after this command
2: Excitation with Delay (P22)
1: 1 Ex Channel
2: 0 Delay W/Ex (units = 0.01 sec)
3: 1 Delay After Ex (units = 0.01 sec)
4: 0 mV Excitation
;use formatter string 101 to transmit the string ‘get data’ to port 1
3: SDM-SIO4 (P113)
1: 1 Reps
2: 0 Address
3: 1 Send/Receive Port 1
4: 2304 Command
5: 9101 1st Parameters
6: 0 2nd Parameters
7: 0 Values per Rep
8: 0000 Loc [ _________ ]
9: 1 Mult
10: 0 Offset
;a minimum delay of 3.8ms is required after this command
4: Excitation with Delay (P22)
1: 1 Ex Channel
2: 0 Delay W/Ex (units = 0.01 sec)
3: 1 Delay After Ex (units = 0.01 sec)
4: 0 mV Excitation
;send the ASCII characters ‘Y’ and ‘Z’ to port 1
5: SDM-SIO4 (P113)
1: 1 Reps
2: 0 Address
3: 1 Send/Receive Port 1
4: 2305 Command
5: 89 1st Parameters
6: 98 2nd Parameters
7: 0 Values per Rep
8: 0000 Loc [ _________ ]
9: 1 Mult
10: 0 Offset