Clarion XAZ611 - Manual (Page 6)

10
XAZ611
English
Basic Operations Note: Be sure to read this chapter referring to the front diagrams of
chapter “3. CONTROLS” on page 5 (unfold).
CAUTION
Be sure to lower the volume before switching
off the unit power or the ignition key. The
unit remembers its last volume setting. If
you switch the power off with the volume
up, when you switch the power back on, the
sudden loud volume may hurt your hear-
ing and damage the unit.
The clock is displayed when the ignition key
is turned to the ACC (accessory) or IGN (ig-
nition-on) position even when the unit
power is off. In some cars, the clock may
momentarily disappear when the ignition
key is turned to the START position. The
clock will reappear after the engine has
started and the ignition key is released to
the IGN (ignition-on) position.
Turning on/off the power
Note:
• Be careful about using this unit for a long time with-
out running the engine. If you drain the car’s bat-
tery too far, you may not be able to start the en-
gine and this can reduce the service life of the
battery.
1. Press POWER button 3 .
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold POWER button 3 for 1 sec-
ond or longer to turn off the power for the unit.
Note:
• System check
The first time this unit is turned on after the wire
connections are completed, it must be checked
what equipment is connected. When the power is
turned on, “SYSTEM CHCK” appears in the dis-
play, so press POWER button
3 . The system
check starts within the unit. When the system check
is complete, the power is turned off, so press
POWER button
3 again.
Selecting a mode
1. Press FNC button 3 to change the mode of
operation.
2. Each time you press FNC button 3 , the mode
of operation changes in the following order:
Radio mode ➜ TAPE mode ➜ CD changer
mode ➜ MD changer mode ➜ TV mode ➜
DVD mode ➜ DAB mode ➜ DSP mode ➜
AUX mode ➜ Radio mode ...
∗
External equipment not connected with CeNET
is not displayed.
Adjusting the volume
Turning the Rotary knob $ clockwise increases
the volume; turning it counterclockwise de-
creases the volume.
∗
The volume level is from 0 (minimum) to 33 (maxi-
mum).
Switching the display
Press DISP button 0 to select the desired display.
Each time you press DISP button 0 , the display
switches in the following order:
Main display
Sub (title) display
Clock display
Main display...
∗
Once selected, the preferred display becomes
the display default. When a function adjustment
such as volume is made, the screen will mo-
mentarily switch to that function’s display, then
revert back to the preferred display several
seconds after the adjustment.
∗
When you have entered a title in a CD, it ap-
pears in the sub display.
If you have not en-
tered a title, “NO-TITLE” appears in the title
display instead. For information on how to en-
ter a title, refer to the subsection “Entering
titles” in the “Other Handy Functions”.
7. OPERATIONS