Sears 831.159341 - Manual (Page 7)

10. Wrap the Weight Cable (52} around a 2* Pulley (4).
Attach the Pulley to the Right Arm (16) with a 3/8' x
1 3/4' Bolt (40) and 3/8' Nylock Nut (6).
lay the Weight Cable (52) over a 3 1 /2' Pulley (5).
Attach a Cable Trap (67) and the Pulley to the side
of the Upright (9) with o 3/8' x 1 3/4' Boll (40)
and 3/B' Nylock Nut (6). Make sure that the Cable
Trap is in the '12 o'clock* position.
11. Wrap the Weight Cable (52) under
a
2' Pulley (4).
Attach the Pulley to the bracket on the side of the
Moment Arm (74) with a 3/8' x 1 3/4' Bolt (40)
and 3/8' Nylock Nut (6). Make sure that the Weight
Cable is between the Pulley and the indicated tab.
Attach the end of the Weight Coble (52) to the right
side of the Leg Developer (23) with a 3/8' x 2 1 /4'
Bolt (45) and 3/8' Nylock Nut (6). Do not overtight­
en the Nyiock Nut, the Cable must be able to swiv­
el heely or it will be damaged.
12. Irisert the threaded bolt on the end of the Weight
Cable (52) into the Adjustment Bracket (53). Fìnger
tighten the 5/16' Nut (82) onto the threaded bolt
until there Is slight tension in the Cable.
13. Wet the upper ends of the Left and Right Arms (15,
16) and the insides of the two Large Pads (17) with
soapy wafer. Slide the Large Pads onto ^ Anns.
Attach the Backrest (19} to the Upright (9) with two
l / 4 ' x 2 1/2-Bolts (46).
10
13