Check list of all step-by-step guides to install – Sears 625.34842 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 1
WATER SOFTENER START-UP
1B.
CHECK LIST OF ALL STEP-BY-STEP GUIDES TO INSTALL
Refer to the Installation Manual, part no. 7159931, for
step-by-step guides.
To be sure you have done all the steps to install the
softener, read the following list. Page numbers
referred to are in the InstaUation Manual
Is the house water supply flow going into the
softener valve INLET? Trace piping to be sure.
See pages 10 and 11.
Is the plumbing bypass valve (or 3 valves) set for
soft water service? See page 18.
Is the valve drain hose connected to the drain fit
ting the right way? Does the drain hose run to the
drain point without sharp bends or kinks that
could stop or reduce water flow? See page 16.
Is the softener power cable connected to the
transformer, and is the transformer plugged into
an inside, 120V-60Hz electrical outlet? See page
20
.
Be sure to restart the water heater. See page 20.
4
lil
Water
Heater
NOTE: The state of Massachusetts recjuires a licensed
plumber to perform the installation.