Jointer-pulley belt guard installation – Sears 113.206930 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8. Snap guard into position as shown.
9. Remove knob and washer . ,. lift guard up.
10.
Loosen, the two MOTOR BASE CLAMP SCREWS and
rotate the motor so that the ventilation slots are facing
downward, tighten base clamp screws.
11.
Install the 2-1/2" pulley on motor and move the
motor sideways until the motor pulley is aligned with
the pulley on the machine.
12.
Install V-Beit and PUSH down on motor to apply
tension
to
the
belt
and
tighten
nuts
on
motor
mounting bolts.
NOTE: It is only necessary to apply enough tension
to the belt to prevent it from slipping in
pulleys while running.
13. After motor and V-belt have been installed and adjusted
for alignment and tension install the metal belt guard to
Leg Set using the holes that are letter coded "B" as
shown on page 8.
14.
Insert motor cord plug through rectangular opening in
side stiffener that is directly under switch box and
then into the receptacle. To prevent damage to motor
cord attach it to side stiffeners using the two (2) cord
clips.
C.
VENTILATION HOLES
FACING DOWNWARD
MOTOR BASE
CLAMP SCREWS
{BOTH ENDS)
WASHER
(CONCAVE SIDE UP)
JOINTER-PULLEY BELT GUARD
INSTALLATION
1. Attach guard to stand with Hex. Hd. screws and nuts.
Make sure belt does not scrape on guard.
2. Replace washer CONCAVE side u p . . .screw on knob.
11