Instalung cutter guard spring, Installing cutter guard spring – Sears 113.206930 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
INSTALUNG CUTTER GUARD SPRING
1. Remove cotter pin from pivot pin in cutter guard and
remove guard (located underneath infeed table.)
Spring must appear as in sketch from underside of in
feed table, it will not perform properly if installed
upside down.
1. Position guard as shown, with PIVOT PIN above hole
in infeed table.
2. Align SLOT in pin with TANG in spring, and press
down.
3. Replace cotter pin.
4. RAISE end of FENCE, rotate guard COUNTER
clockwise only enough to CLEAR fence.
5. LOWER fence and tighten both knobs.
23
Advertising
This manual is related to the following products: