Sears 113.206930 - Manual (Page 26)

froyble shooting
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE TROUBLE SHOOTING YOUR JOIN­
TER-PLANER.
TROUBLE SHOOTING CHART
TROUBLE PROBABLE CAUSE REMEDY
Motor will not run. 1. Defective On-Off switch.
Defective switch cord.
Defective switch box receptacle.
2. Motor protector open, (only if
your motor is equipped with an
overload protector).
Other cause
1. Replace defective parts before using
machine again.
2. Consult Sears Service. Any attempt to
repair this motor may create a HAZARD
unless repair is done by a qualified service
technician. Repair service is available at your
nearest Sears Store.
Wood strikes outfeed
table after passing over
cutterhead. Blades improperly adjusted below
surface of outfeed table.
Re-adjust blades, see Maintenance section.
Ripples on planed
surface.
1. One blade set higher than other.
2. Feeding wood too fast.
1. Re-adjust blades, see Maintenance
section.
2. Feed wood slower.
Planed surface not
straight.
Infeed table out of adjustment. Re-ad|ust infeed table, see Getting To Know
your Jointer Planer section.
Excessive gouging at end
of cut.
Blades set too high above outfeed
■ table. "" ................................ o'i/".,,' ■
Reset blades, see Maintenance section.
90° and 45° cuts
inaccurate. 1. Fence stops not adjusted properly.
2, Fence slide bracket not even With
. 'table. . ■ , ■ , ■ ■ ■ ■ ■ ■ ■ , '
1. Re-adjust fence stops, see Getting To
Know your Jointer Planer section.
2. Re-adjust slide bracket, see Getting To
Know your Jointer Planer section.
Infeed table loose. 1. Dovetail spacer requires adjustment.
2. Female dovetail loose from table.
1. Tighten screw, key 10, see fig. 2, Parts List.
2. Tighten screws, key 18, see fig. 2, Parts List.
Cutter guard does not
function properly. 1. Return spring broken, or spring
has been weakened.
1. Replace spring immediately. See
Maintenance section.
2. Improper assembly of spring or
guard mounting.
2. See Maintenance section.
RECOMMENDED ACCESSORIES
ITEM CAT. NO.
Steel Legs ......................................................... 9-22245
Floor Stand .. ........... ........................................... 9-22216
Cutter Blades ........ ....... ...................................... 9-2293
Power Toot Know-how Handbooks
Radial Saw ..................................................... . 9-2917
Table Saw ........................................................ 9-2918
Knife Setting Gauge ............................................ 9-2647
The above recommended accessories are current and were
available at the time this manual was printed.
26