Sears 113.206930 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
h. Loosen four lock screws 2 or 3 turns with 1/2 in.
wrench.
LEVELING STUDS
LOCKSCREWS
VIEW LOOKING UP FOR PARTS IDENTIFICATION
turning the
leveling
STUDS will RAISE or LOWER
the infeed table.
SCREWING in the studs will RAISE the table . . .
UNSCREWING them will LOWER the table.
a. With 3 3/4 in. wrench turn leveling studs until
infeed table is parallel with straightedge.
b. While holding studs with wrench, TIGHTEN all
four LOCKSCREWS .. . tighten each screw a little
bit at a time until all four screws are tight.
o.
Recheck with straightedge to make sure infeed
table is parallel to outfeed table.
ON-OFF SWITCH: It is unlikely that it will be
turned "ON" accidentally, when touched or bumped,
because of the way it is shaped.
In an emergency, it can be turned "OFF" by striking
itwitfi the palm of the hand.
The "yellow button" is a key. When inserted in the
switch lever, the power may be turned ON and OFF.
When it is removed, the power cannot be turned ON.
THIS FEATURE IS INTENDED TO PREVENT
U N A ÜT H O R I Z E D AND POSSI B LE
HAZARDOUS USE BY CHILDREN AND
-OTHERS.,;:;:,,,,.,,.^': ■ ■■■■■""'" '
■
a. insert Key into switch.
...
NOTE: Key is made of yellow plastic.
16