Sears 113.241591 - Manual (Page 14)

TILT MECHAiHSfi ■
Lower blade to 2 inches or closer to the tabletop
before tilting blade. Failure to do this may result in
damage to your saw.
The handwheel should turn freely without binding.
The turning action can be adjusted by tightening or
loosening the screws in the bearing retainer
NOTE: Tilt Handwheel must be removed to adjust.
When adjusting the screws in the bearing retainer
using a screwdriver, hold the nut inside using a 3/8
in. wrench.
fWIOUNTING THE MOTOR
1. CHECK WOTOR ROTATION
A. The motor must rotate COUNTER —
CLOCKWISE when viewed trom the shaft end.
B. MAKE SURE “KEY” IS REMOVED FROM
SHAFT.
C: Place the motor on your workbench or on the
floor.
D. Plug the cord into a property grounded outlet
{See “Motor Specifications and Electrical
Requirements” Section.) Notice the rotation
of the shaft. If it is not turning
COUNTERCLOCKWISE, do not continue
assembly. Contact your nearest Sears Store or
Service Center.
E. Remove plug from outlet.
ROTATION
W A R N I N G : T O A V O I D I N J U R Y F R O M
ACCIDENTAL START, MAKE SURE MOTOR IS
NOT PLUGGED INTO SWITCH OR ANY OTHER
ELECTRICAL OUTLET
2. From among the loose parts find the following:
1 Motor Mount
2 Carriage Bolts 1/4-20 x 3/4 in. long
2 Hex Nuts 1/4-20 (aprox. dia. of hole 1/4 in.)
2 Lockwashers External Type 1/4in. (approx.dia.
of hole 1/4 in.)
3. Insert carriage bolts through square holes in rear
panel of table saw and through square holes in
motor rriount. Install lockwashers and hex nuts.
4. Tighten nuts.
14