Sears 113.241591 - Manual (Page 37)

DADOIMG .
Instructions for operating the Dado Head are
contained in booklet furnished with the Dado Head.
The Recommended Dado Head is listed under
Recommended Accessories in this manual.
The arbor on the saw, is only long enough so that
the widest cut that can be made is 13/16” wide.
It is not necessary to install the outside loose collar
before screwing on the arbor nut. Make sure the
arbor nut is tight.
ALWAYS USE DADO INSERT LISTED UNDER
RECOMMENDED ACCESSORIES.
When using the dado head it will be necessary to
remove the Blade Guard and Spreader. Use Miter
Gage and follow same procedures and Instructions
for Cross Cutting.
ALWAYS REPLACE THE BLADE, GUARD AND
SPREADER
WHEN YOU ARE FINISHED
DADOING.
MOLDING CUTTING
instructions for operating the Molding Head are
contained in a booklet furnished with the Molding
Head.
The recommended molding head is listed under
Recommended Accessories in this manual.
Always use Molding insert listed Under
Recommended Accessories.
When using the molding head it will be necessary to
remove the Blade Guard and Spreader. USE
CAUTION. USE FEATHERBOARDS AND PUSH
STICKS, etc, AS REQUIRED.
ALWAYS REPLACE THE BLADE GUARD AND
SPREADER
WHEN YOU ARE FINISHED
MOLDING.
USING FEATHERBOARDS
Add 8 inch high flat facing board to the fence, the
full length of the fence.
Use featherboards for all non ‘‘thru-sawing”
operations (when sawblade guard must be
removed). Featherboards are used to keep the work
in contact with the fence and table as shown, and to
stop kickbacks.
Mount featherboards to fence and table as shown,
so that leading edges of featherboards will support
workpiece until cut is complete, and the workpiece
has been pushed completely past the cutter
(sawblade, dado head, molding head, etc.) with a
pushstick, as in ripping.
“C O.AMPS
featherboabo
WORK SUPPORT
Before starting the operation (switch “OFF" and
cutter below table surface):
(a) Install featherboards so they exert pressure on
the workpiece; be positive they are secure, and
(b) Make sure by trial that the featherboards will
stop a kickback if one should occur.
Featherboards are not employed during non thru-
sawing operations when using the miter gauge.
Replace the sawblade guard as soon as the non
thru-sawing operation is complete.
37