Sears 113.241591 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5.
Turn front bar end for end and insert bolts
through holes in middle and on right sides of
front of saw table as illustrated . . . install
lockwashers and nuts, DON’T SCREW NUTS
ON ALL THE WAY, Just get them started on the
screws.
6.
Insert 1 in. long screws in SECOND and
FOURTH or FIFTH holes of rear bar and attach
to table the same way as front bar.
7.
Insert ends of FENCE GUIDE BAR ROD
through holes in bars as illustrated.
NOTE: The ends of the ROD are not threaded...
the SELF THREADING NUTS will cut threads
on the rod as they are screwed on. Just start n uts
onto ends of rod.
8 Hold rod with one hand and with a 1/2 in. wrench
or pliers start screwing on ONE of the nuts only
A TURN OR TWO . . . screw on other nut the
same way. ^ ^
^
9. Using TWO 1/2 In. wrenches or pliers tighten
both of the nuts.
10. Slide the bars so that screws are in the M! DOLE
of the slotted holes,
11. Lift rip fence lock lever and position rip fence
over miter gauge groove, holding up the rear
end while engaging front end with bar ... lower
fence onto table.