Sears 113.241591 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
WARDING:
TO
AVOID
INJURY
DUE
TO
ACCIDENTAL START, TURN SWITCH “OFF" AND
REMOVE PLUG FROM POWER SOURCE OUTLET.
2. MAKE SURE THE BLADE fS ALL THE WAY UP
AND SQUARE WITH THE TABLE.
3. Position S
preader
support
on rod behind
the rip fence guide bar.
BLADE SQUARE
WITH TABLE
GUIDE BAR
4, Asserhble the 7/8 in. long setscrews, nuts,
lockwashers and washers to the SPREADER
SUPPORT BRACKET and slip the nuts into the
slot in the spreader support.
5, Locate spreader supportand bracketon rod, 1/16
inch behind the fence guide bar.
6, Finger tighten ONLY THE HEX NUTS.
24
Advertising