Sears 831.15403 - Manual (Page 11)

Arm Assembly
16. Grease an M10 x 108mm Bolt (99). Orient the
Press Frame (13) as shown. Attach the Press
Frame to the Left Base (2) with the Bolt and an
M10 Nylon Locknut (114).
Do not overtighten
the Locknut; the Press Frame must be able to
pivot easily.
17. Remove the M10 x 45mm Button Bolt (105) from
a Press Arm (14).
Attach a Press Handle (16) to a Press Arm (14)
with an Ml 0 X 65mm Bolt (96), two M10 Washers
(116), two M10 X 12mm Spacers (75), and an
M10 Nylon Locknut (114).
Attach a Press Arm Cap (56) to the Press Arm
(14) with an Ml 0 X 45mm Button Bolt (105) and
an M10 Large Washer (134).
Attach the Press Arm (14) to the Press Frame
(13) with two M8 X 70mm Bolts (97) and two M8
Nylon Locknuts (115).
Repeat this step with the other Press Arm
(14) .
18. Grease an M10 x 108mm Bolt (99). Attach the
Leg Press Frame (12) to the Left Base (2) with
the Bolt and an M10 Nylon Locknut (114). Do not
overtighten the Locknut; the Leg Press Frame
must be able to pivot easily.
Grease an M10 x 77mm Bolt (133). Attach the
Foot Plate (23) to the Leg Press Frame (12) with
the Bolt and an M10 Nylon Locknut (114). Make
sure the decal on the Foot Plate is right side
up. Do not overtighten the Locknut; the Foot
Plate must be able to pivot easily.