Sears 831.15403 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
10. Identify the Front Weight Guides (136), which
have the lock holes closer to the center than the
Rear Weight Guides (24). Orient the Weight
Guides with the holes closer to the bottom.
Attach the Front Weight Guides (136) to the Right
Base (1) with an M10 x 155mm Bolt (130), two
M10 Washers (116), and an MIO Nylon Locknut
(114).
Slide two Weight Bumpers (65) onto the Front
Weight Guides (136). Slide the ten Weights (35),
with the pin holes on the indicated side, onto the
Weight Guides.
Press a Weight Tube Bumper (66) into the Long
Weight Tube (36). Insert the Weight Tube into the
stack of Weights (35).
Make sure the pin on the
Weight Tube sits in the groove on the top
Weight.
Grease the indicated holes in a Top Weight (34)
with an included grease pack. Slide the Top
Weight onto the Front Weight Guides (136).
Repeat this step with the Rear Weight Guides
(24) and eight Weights (35).
11. Attach the Right Top Frame (7) to the Right
Upright (4) with two M8 x 80mm Bolts (94), two
M8 Washers (117), and two M8 Nylon Locknuts
(115). Do not tighten the Locknuts yet.
Attach the Right Top Frame (7) to the Left Top
Frame (8) with two M8 x 80mm Bolts (94), two
M8 Washers
(117),
and two M8 Nylon Locknuts
(115). Do not tighten the Locknuts yet.