Seat assembly – Sears 831.15403 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
61. Attach the end of the Leg Press Cable (69) to the
“□"-bracket (50) with an MS Washer (117) and an
MS Nylon Locknut (115).
Note: Do not complete
ly tighten the Locknut; It should be tightened
so that oniy two threads of the Cable show
past the Locknut, as shown in the inset draw
ing.
Seat Assembly
62. Attach the Seat (29) with the serial number decal
on the bottom to the Right Seat Frame (9) with
four M6 X 16mm Screws (85).
Repeat this step with the other Seat (29) and
the Left Seat Frame (not shown).
63. Attach a Backrest (28) to the Right Upright (4)
with four M6 X 16mm Screws (85).
64. Attach a Backrest (28) to the Backrest Frame (27)
with four M6 X 16mm Screws (85).
Slide the Backrest Frame (27) into the Left
Upright (5). Engage the Knob (121) into the
Upright and Backrest Frame, and turn it clockwise
until it is tight.
.,50
115
62
63
21