Sears 831.15403 - Manual (Page 19)

51. Route the Right Stack Cable (70) down through
the Right Top Frame (7) and over a 90mm Pulley
(39). Attach the Pulley and a Small Cable Trap
(48) inside the Top Frame with an M10 x 80mm
Bolt (111), two M10 Washers (116), a 19mm
Spacer (77), a 16mm Spacer (124), and an M10
Nylon Locknut (114).
Make sure the 16inm
Spacer and the Small Cable Trap are on the
same side of the Pulley.
52. Set an Ml 2 Washer (129) on top of the Long
Weight Tube (36). Thread an Ml 2 Nut (128) all
the way onto the Right Stack Cable (68).
Thread the Right Stack Cable (68) into the Long
Weight Tube (36). Tighten the Ml2 Nut (128)
against the Ml 2 Washer (129).
53. Locate the Press Cable (69). Grease an M8 x
86mm Shoulder Bolt (86). Attach the Cable to the
Leg Press Frame (12) with the Bolt, an M8
Washer (117) and an M8 Nylon Locknut (115).
54. Wrap the Press Cable (69) around a 90mm
Pulley (39). Attach the Pulley, two Half Finger
Guards (42), a Small Cable Trap (48), and an
MIO Washer (116) to the Left Seat Frame (10)
with an MIO
X 103mm Bolt (106), an MIO Washer
(116), and an MIO Nylon Locknut (114). Make
sure the Cable Trap and Finger Guards are
oriented as shown.
55. Wrap the Press Cable (69) around a ‘V-pulley
(40). Attach the “V”-pulley, two Half Finger Guards
(42), and two MIO Washers (116) to the Leg
Press Frame (12) with an MIO x 118mm Bolt
(100), an MIO Washer (116), and an MIO Nylon
Locknut (114).
Make sure the Finger Guards
are oriented as shown.