Amana ART6002 - Manual (Page 21)

Care and Cleaning
Removing Oven Door Replacing Oven Light
À CAUTION
To avoid personal injury or property damage, handle
oven door with care,
• Door is heavy and can be damaged if dropped.
• Avoid placing hands in hinge area when door is
removed. Hinge can snap closed and pinch hands.
• Do not scratch or chip glass, or twist door.
Glass may break suddenly.
• Replace door glass if damaged.
• Do not lift door by handle.
1
.
2
.
Open door fully.
Remove screws.
• Oven doors are attached with a screw on each side
of lower oven door.
Close door to first stop, grasp door firmly on each
side, and lift upward until door is off hinges.
• Do not lift door by handle. Glass can break.
• Only push hinges closed once oven door is
removed if necessary. Use both hands when
closing hinge. Hinge snaps closed.
Removing Oven Door
Removing Storage Drawer (Some Models)
1. Slide drawer out until it stops.
2. Grasp drawersides near back of drawer.
3. Lift up and out. Reverse to reinstall.
^ WARNING
To avoid risk of burns or electrical shock, disconnect
electrical supply to oven before changing light bulb.
• Before replacing light bulb make sure bulb is cool.
• Do not operate oven without bulb and cover in place.
À CAUTION
Wear gloves to protect hands from accidental bulb
breakage.
1
.
2
.
3.
4.
5.
6,
Disconnect electrical supply.
Remove oven door if desired.
Unscrew light bulb cover located in rear of oven
cavity. Then turn light bulb counterclockwise to
remove.
Replace light bulb with 120-volt, 40-watt appliance
bulb.
• Do not overtighten bulb or it may be difficult to
remove later.
Replace light bulb cover and oven door before use.
Reconnect power supply.
Replacing Oven Light Bulb
Removing Panel (Some Models)
1, Remove 2 screws at bottom of panel.
2, Push panel up so tabs on top of panel clear range
frame,
3, Lift panel away from range.
• Reverse to reinstall.
21