Onkyo TX-8211 - Manual (Page 12)

Connecting the power
Before plugging in the unit, confirm that all connections have been made properly.
Before turning on the power, be sure that the VOLUME knob is fully turned counterclockwise.
Turning on this unit’s p>ower may cause a momentary power surge, which might interfere with other electrical equipment, such as comput­
ers. If so, use a wall outlet on a different circuit.
POWER switch
SYSTEM switch
U.S. and Canadiiiii models:
Plugging the TX-82U’s power cord into an AC outlet puis tlie
unit in stand-by status (the STAND-BY indicator is lit). Pressing
the POWER switch turns on the unit and lights up the display. If
this switch is pressed again, the unit returns to the .stand-by status.
Tlie POWER button on the remote control is u.sed in the same way
as the POWER switch on the TX-8211.
Models other than U.S. and Canadian models:
After plugging the TX-8211's power cord into an AC outlet, pre.ss
the SYSTEM switch to pul the unit in power-on status (the unit
tan be operated and its display is lit). The remote control cannot
be used to operate the TX-8211 if the SYSTEM switch is not set to
ON.
When the SYSTEM .switcli is set to ON, pressing the POWER but­
ton on the remote control switches the TX-8211 between stand-by
status (the STAND-BY indicator is lit) and power-on status (the
display will light up).
Pressing the SYSTEM switch on the TX-8211 to .set it to OFF
turns off the unit. (When the SYSTEM switch is set to OFF. only a
small amount of power is used.)
12