Onkyo TX-8211 - Manual (Page 16)

Receiving stations
ir you tune in a stereo FM station, the STEREO indicator will be
illuminated if the signal is sufficiently strong.
If the signal is weak, it may be impossible to tune into your
desired station. In this case, tunc in as follows.
Press the FM MUTE/MODE button and FM MUTE OFF lights up.
At this time, the station will be in mono and interstation noise will
be heard.
Select the station you want to listen to.
This unit is equipped with an APR system to help tune in FM sta­
tions.
When receiving an FM station using manual or direct tuning, RF
MODE LOCAL/DX and STEREO MODE AUTO/MONO settings
are made automatically, according to the station being received.
The APR system automatically sets the gain of the RF section to
DX or LOCAL according to the quality of the signal being
received. The RF MODE will indicate LOCAL when a sufficient
signal is received.
If the MONO indicator lights up while a station is tuned in. the
station will be received in mono even if it is a stereo station.
The STEREO MODE AUTO/MONO settings that the APR system
makes can be changed by pressing the FM MUTE/MODE button.
16
3 2
i iir*%TEf€0
uot*^ Mooe
ON
t » IUU> «
»1640
UU*I
1 h / l 1 I I 1 n 1
mnrm
1 1 1 D U. -1 CM
MMOftv <wacc
r I I U I 1 1 1
r I I - l U . U U u .
\.“®'
I h / l I . I I . 1 I I I I
ril _/(_/. u<_/_
I h ' l I I I . J I I I I
i ' l l -lU.UU^
0^
-L.
; Programming radio stations- J
Since ten AM or FM stations can be stored
in each group (A, D or C), a total of 30 sta­
tions can be stored in the memory.
1. Select the frequency that you want to
store in the memory.
(Refer to “Tuning the radio" on page
15.)
2. Pre,ss the MEMORY button.
The MEMORY indicator will light for
8 .seconds.
3. While the MEMORY indicator lights,
press the GROUP button to choose
the desired group.
The group shown on the display
changes in the following order each
time the button is pressed: A —» B —> C
^A...
4. Select (he desired memory num­
ber using the number buttons.
Press button 0/10 when choosing mem­
ory number 10.
NOTE:
If the FM station received is an RDS sta­
tion with a PS (Program Service Name),
the frei|uency display will change to the PS
display. II' there is no PS, the frequency
display will not change.
(Refer to pages 18 and 19 for more details
on the RDS function.)