Control cable bracket assembly, Control cable bracket adjustment, Tire pressure – Troy-Bilt 42000 User Manual
Page 11: Engine oil, Warning, Auger gear case
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Section 2: Assembly (continued)
Control cable bracket assembly
1. Using a 3/8 wrench, secure the cable
brackets (R) to the insides of the
handlebars with one 1/4-20 x 7/8 hex
bolts each.
2. Pull down on each cable so the
control levers (P and Z) contact the
handlebar. Insert the adjustment
barrel (F) of the cable assemblies
into the slots in the cable brackets
(R). Position adjustment barrels on
the cable assemblies so the cable
brackets (R) are between the two
nuts on the cable assembly
adjustment barrels.
Control cable bracket adjustment
The cable assemblies should be adjusted
so the control levers are held against the
handlebars under a slight tension. Adjust
as follows:
1. Unscrew the top adjustment nut (S)
on the cable adjustment barrel several
turns.
2. Adjust the lower adjustment nut on
the cable adjustment barrel until the
control lever is held against the
handlebar under a slight tension.
3. Using two 1/2” wrenches, hold the
lower nut on the adjustment barrel
and tighten the upper nut down until
the cable bracket (R) is securely
tightened against the cable bracket.
4. Repeat on the other side.
Tire pressure
Use an automotive-type tire pressure
gauge. Inflate both tires evenly 15—25
PSI (103-171 Kpa).
Engine Oil
WARNING
DO NOT START THE ENGINE
UNTIL ENGINE CRANKCASE
HAS BEEN FILLED WITH OIL.
FAILURE TO FOLLOW THIS
INSTRUCTION WILL RESULT IN
SERIOUS ENGINE DAMAGE.
1. To add engine oil, unscrew the
dipstick (T, Fig. 2-7). Fill engine at
dipstick opening with fresh oil. Refer
to the engine owner manual for
correct oil specifications.
2. The oil level on the dipstick should
always be between the “ADD” and
“FULL” marks. Wait ten minutes after
the filling the crankcase for the oil to
settle. Re-check the oil level and
adjust as needed.
Auger gear case
The auger gear case was filled at the
factory with the correct amount of SAE 90
gear oil. Check the level before using the
unit. Refer “Lubrication” in the
“Maintenance” section of this manual for
transmission gear oil instructions.
11