Cradlepoint CBR450 - Manual (Page 63)

CRADLEPOINT
CBR450| USER MANUAL Firmware ver. 3.3.0
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 61
6.5.3 Local Network Interfaces
Each LAN type —Ethernet and VLAN—has a separate section with configuration options. Unless the default configuration
is sufficient, YOU MUST CONFIGURE EACH INTERFACE SEPARATELY in order to create the desired interface options
for a network. You can then select these interfaces to add to a network in the Local Network Editor (see above).
Select from the following tabs:

Ethernet Port Configuration

VLAN Interfaces
Ethernet Port Configuration
Ethernet Port Configuration provides
controls
for your router‘s Ethernet port.
You have the ability to control the Link
Speed.
While there is a dropdown menu with
multiple options listed (LAN, WAN, and
disabled) for the Ethernet port type, THIS
MUST REMAIN ON THE “LOCAL
NETWORK (LAN)” SETTING. Most
CradlePoint routers allow different settings for the Ethernet ports, but the CBR450 only has one option for LAN. You will
lose connection to your router if you change this setting.
Link Speed: Default setting is Auto. The Auto setting is preferred in most cases.

Auto

10Mbps - Half Duplex

10Mbps - Full Duplex

100Mbps - Half Duplex

100Mbps - Full Duplex

1000Mbps - Full Duplex