Storage, Instructions, Storage instructions – Bolens 248-604A User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DEM A
POSITION
Flush
Reverse
5/16"
Neutral
1/2"
Forward
FIGURE 22
Pressure Relief Valve Setting.
If the pressure relief valve is set too low it will open up
before enough pressure is built up to properly operate
the ram. (See figure 23)
To set the Pressure Relief Valve:
1. Remove the acorn nut on the Relief Valve.
2. Loosen the locknut.
3.
Have someone place a log crossways in the
Splitter and allow the Rarn to push against it with
the engine running wide open.
4.
If the engine begins to lug down, the Relief Valve
setting is correct.
5.
If adjustment is necessary, tighten the screw until
the engine begins to lug down.
Shut off the engine, tighten the locknut and
replace the acorn nut.
PRESSURE RELIEF VALVE
LOCKNUT
SCREW
FIGURE 23
STORAGE
INSTRUCTIONS
In event engine is to be stored for any length of
time (30 days or more), prepare as follows;
1. Drain gasoline by tipping or by syphon hose,
then run engine until remainder is used and tank
and carburetor are empty.
A
CAUTION
Drain into container outdoors away
from fire or flame.
Drain carburetor by running engine until it stops
Inside protecting of engine for storage is per
formed by removing spark plug and pouring one
ounce of SAE 30 oil through spark plug hole
into
cylinder.
Crank
engine,
without
starting,
several times to spread oil over cylinder walls.
4. Never store outside without a waterproof cover.
2
.
3.
11