Im portant, Safe operation practices for log splitters, Training – Bolens 248-604A User Manual

Page 3: Preparation, Operation, Maintenance and storage

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

IM P O R T A N T

It is suggested that this manual be read in its entirety before attempting to assemble or operate. Keep

"N this manual in a safe place for future reference and for ordering replacement parts.

This unit is shipped WITHOUT GASOLINE or OIL. After assembly, see operating section of this manual
for proper fuel and amount.

Your log splitter is a precision piece of power equipment, not a plaything. Therefore exercise extreme

caution at all times.

SAFE OPERATION PRACTICES FOR LOG SPLITTERS

TRAINING

1.

Know the controls and how to stop quickly-

READ THE OWNER'S MANUAL.

2.

Do not allow children to operate. Do not allow

adults to operate it without proper instruction.
Only persons well acquainted with these rules of
safe operation should be allowed to use your log
splitter.

PREPARATION

1.

Do not wear loose fitting clothing that could get

caught on the moving parts.

/"^2. Do not operate equipment when barefoot or wear-

^ ing open Sandies. Always wear substantial foot­

wear.

3.

Check the fuie before starting the engine. Do not

fill the gasoline tank indoors, when the engine is
running, or while the engine is still hot. Wipe off
any spilled gasoline before starting the engine.

4. Use only in daylight or in good artifical light.

5.

Never operate the equipment in the rain. Always

be sure of your footing.

OPERATION

1.

Do not change the engine governor settings or

overspeed the engine. Excessive engine speeds are
dangerous.

2.

Do not put hands or feet near rotating or moving

parts.

3.

If the equipment should start to vibrate abnor­

mally, stop the engine and check immediately for

the cause. Vibration is generally a warning of
trouble.

4.

When cleaning, repairing or inspecting, make

certain all moving parts have stopped. Disconnect
the spark plug wire, and keep the wire away from

^ the plug to prevent accidental starting.

Handle gasoline with care-it is highly flammable.

A. Use approved gasoline container.

B.

Never remove cap or add gasoline to a running

or hot engine or fill guel tank indoors. Wipe
up spilled gasoline.

C.

Open doors if engine is run in garage-

exhaust fumes are dangerous. Do not run
engine indoors.

6.

Always operate the log splitter from the engine

side of the beam.

Stand behind the ram when operating. See drawings.

Be careful not to touch the muffler after the

engine has been running, it is HOT.

MAINTENANCE and STORAGE

1.

Keep all nuts, bolts, screws, hose clamps and

hydraulic fittings tight to be sure equipment is
in safe working condition.

2.

Never store the equipment with gasoline in the

tank inside of a building where fumes may reach
an open flame of spark. Allow the engine to cool

before storing in any enclosure.

3.

To reduce fire hazard keep engine free of grass,

leaves, wood chips, excessive grease and oil.

4.

Do not change the engine governor settings or

overspeed the engine. Excessive engine speeds

are dangerous.

5.

Never store outside without a waterproof cover.

Rain will cause rust on the inside of the cylinder.

Advertising